I need a little input here, could someone tell me where in the mach software do you assign the jog for .001,.010,etc am i missing something
I need a little input here, could someone tell me where in the mach software do you assign the jog for .001,.010,etc am i missing something
Config>General Config, or try the tab key.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)