Longtime Mastercam user going UG
Due to economic circumstances, I was forced to change employers and train into UG NX4. Hey....I'm just glad to find a job!
Wow, talk about feeling like an idiot (read signature). I'm looking forward to some good posts in here. I hope to learn the tricks and short cuts.....FAST!
My opening question. Is there a decent set-up sheet for UG. I'm looking for a two mouse click set-up sheet that will give me all relevent tool info.
- maximum tool depth
- type of operation
- step-over / or step down
- tool number and description
- etc. etc.
So far I have not found any thing that can give me this much info. In MCX i had downloaded a freeware that I used in a chook. Is there any such thing available?
"Never argue with an idiot, they'll bring you down to their level, then beat you with experience."