[sippelsteelfab1]

SDS/2 exports DSTV files that we are trying to incorporate with our Ficep Drill/Torch Line.
We are running the latest General release of SDS/2 - 7.32, and we are Running
Arianna Ver. 5.14. The imports are far from cooperating with each other.
Any weld prep cutting that is imported gives the program fits and errors.
We have got most of the bugs out of the block copes and drill problems,
but I was wondering if anyone else out there has had any of the same problems
with either of these software packages.

We can bring DSTV files into our Peddimat program with very littel issue @ all.
any info on this would help immensly.

Thanks in advance for anyone out there taking the time to read and reply.

Jeff

[Peddinghaus2]

When did these problems start happening - was this prompted by updating SDS?

I know that frequently when the outside software firms change something the proprietary software needs to change in order to keep the bugs out.

Did you get this issue resolved?

I hope you got everything up and running again.

[VoortmanSteelMachinery]

Make sure you invest in Voortman in the future and all your importing problems are history.