Wondering if anyone has had a problem using a K value smaller than .01"
G83 J13 Z-.195 K.005 R0. F2.2 (K.005 WILL NOT WORK)
It pecks a few times then just sits there with the spindle running.
Thanks
Wondering if anyone has had a problem using a K value smaller than .01"
G83 J13 Z-.195 K.005 R0. F2.2 (K.005 WILL NOT WORK)
It pecks a few times then just sits there with the spindle running.
Thanks
I think the tool definition controls the peck allowance. I changed the definition to .039" diameter and it allowed a .005" peck.