[machineryaxis]

i have a okuma lathe with a fanuc 0t control. My problem is, my machine lost parameters due to low battery. Im able to manually input parameters but not able to input diagnostics such as timers. I dont have any of the parameters on disk just on paper. I normally turn on the control, activate e-stop,select mdi and even edit, turn pwe on, and attemp to input data but no luck. Am i missing something? i was able to input all the parameters including the 900's. all im missing is the diagnostics. thanks larry

[avtechmachine]

I think you may need to go to OPERATOR'S PANEL page, their is a key switch need to turn on to change DGN
Ahn Vuong

[machineryaxis]

would you happen to know what data i need to change? ill check it out . thanks for your input.

[avtechmachine]

See attachment what the Operator's panel page looks like
Ahn Vuong

[machineryaxis]

ill check my machine thanks for the help

[janne1]

can it be parametr from femco durga? i have them all o-700 parametr and later all diagn.
i have them and you can get them tommorrow..
i have the same fanuck ot-c mainboard A20B-1003.....
ver. soft 660-09 servo 9030-10..
and trouble to send data to machine rs232 with cimco-edit.....but NO problem to save machines files on pc
all the best
jan
sweden