This is my prob:
On a large workpiece (Ø650mm) i am doing the following.
Probing for center on 1 side making this X1Y1Z1
Turning table to 90 deg. then Y1 is to be Y2
How do I do this ???
Best regards (from Denmark so sorry for incorrect spelling etc... )
Kjeld
Results 1 to 1 of 1
-
03-23-2009, 03:37 PM #1
Registered
- Join Date
- Mar 2009
- Posts
- 1
Mazatrol Fusion 640 M "Copying Y1 to Y2"
Reply With QuoteSimilar Threads
-
"low end" HF Spindle or "high end" router for about $1000?
By biomed_eng in forum DIY CNC Router Table MachinesReplies: 14Last Post: 01-06-2012, 07:15 AM -
"Warco GH Univ" V "Chester Lux Mill"
By JQ_Quint in forum Benchtop MachinesReplies: 37Last Post: 01-22-2009, 05:59 PM -
BattleAxe "aka" Ball and Chain "aka" the wife.
By ZipSnipe in forum Community Club HouseReplies: 48Last Post: 05-18-2008, 03:53 PM -
G320 "common" or "+5vdc" why do they vary?
By beezerlm in forum Gecko DrivesReplies: 3Last Post: 01-12-2008, 11:00 PM -
Vertical system "jerks" and "bangs"??
By REVCAM_Bob in forum Servo Motors / DrivesReplies: 5Last Post: 06-12-2006, 03:09 PM
Posting Permissions
