Does anyone know what parameter turn off the orange blinking light that comes on when a program reaches it's M30? It is driving me nuts. Thank you.
Does anyone know what parameter turn off the orange blinking light that comes on when a program reaches it's M30? It is driving me nuts. Thank you.
Also, we have the same control on 2 machines. Both are Hardinge VMC's. On the VMC1000, the Z displays to the actual Z that is programmed as it is running, ex. prg to Z-.5 it reads Z-.5 on the screen. On the VMC600, the Z stays at machine Z, ex. prg Z-.5 it reads Z-13.75 on screen. Does anyone know the parameter to change so I can get both to read the same? I would like the screen to display programmed depth. I hope that is not too confusing. Thanks.
I have no books. Old machines, I just got here.
I think it is parameter 28.0 but i am not sure. This sets absolute display or relative display on the program check screen.
Send me a PM with your email and I will shoot over the books.
Stevo
For the first problem, it is related to machine, if you have maintenance manual of machine, try to find something about warning light.
Second, if I understand you correctly, maybe that you have some WORK SHIFT other than 0, or you have to make manual reference return?
Sorry for bad english
Stevo,
I will look at 28. It is the check screen read out.
Thanks.
Padobranac,
I will see if there is a maintenance manual. I know there are no parameter ones.
Thanks.
Compare #18 bit 5 on both machines.
Problems solved. Thanks folks. It was a combo of #28 and #18. That is just what I wanted.
Fixed the lights too. Got tired of screwing around trying to find a parameter or switch, and just pulled the bulbs.
Thanks for the help.