Hi Gents,
In v655/80 MAZAK (M32B) machines tool length measuring unit I wants to change the position, my problem is T MSR auto mode working in particular position only, we can change that? Any option is there pls assist. Thanks.
Thread: T MSR AUTO MODE IN MAZAK!
Results 1 to 3 of 3
-
03-27-2009, 06:13 PM #1
Registered
- Join Date
- Mar 2009
- Posts
- 6
T MSR AUTO MODE IN MAZAK!
-
03-28-2009, 05:26 AM #2
Registered
- Join Date
- Mar 2005
- Posts
- 988
Yes, you can change the position. It's an R parameter but I can't remember which one right off the top of my head. Maybe someone with the list can chime in...
It's just a part..... cutter still goes round and round....
-
03-28-2009, 10:34 PM #3
Registered
- Join Date
- Jan 2009
- Posts
- 55
r parameters
The tool setter position and height are set in the R parameters i belive around R2392. Look in the electrical diagram book there will be a list of them in there. I know there is also a R parameter that allow the mesurement of endmills. Sorry i dont have a book at home or i would tell u that the actual parameter numbers are.
Reply With QuoteSimilar Threads
-
Drip feed mode for Mazak M32
By CimUser2000 in forum Mazak, Mitsubishi, MazatrolReplies: 5Last Post: 07-12-2010, 01:55 AM -
Mazak QT15 with T32-B control does not switch to automatic mode
By MarkusFunk in forum Mazak, Mitsubishi, MazatrolReplies: 2Last Post: 06-06-2008, 03:54 AM -
Mazak Integrex 100Y Subspindle Milling Mode not working
By mzbik in forum G-Code ProgramingReplies: 3Last Post: 01-22-2007, 07:59 PM -
Using G12.1 Milling Mode on a Mazak Integrex
By mattclubb in forum Mazak, Mitsubishi, MazatrolReplies: 8Last Post: 12-23-2006, 06:24 AM -
Single line mode works well, Auto is not soo good??
By Darc in forum CamSoft ProductsReplies: 16Last Post: 10-26-2004, 09:29 PM
Posting Permissions
