I have been trying to get my CNC Milling Machine to Cut my Gcode that I sent to it from MasterCam X2. Everytime I start the program in the Prolite mill I am not in the center of the work piece in the Vise...
My Question is:
How do I setup my work piece that is 6"long 2.5" wide and 1/2" thick.
I used an Edge Finder at the Top LEFT of the work piece...
I Zeroed out X axis when the edge finder was on Center.
I moved to the Top of the Y axis and did the same zeroed Y.
I put a piece of paper on top of the piece and put Z axis down till it wouldnt allow me to move the Paper out, I Zeroed Z axis.

I go to cut and all the cuts are on the Lower Half of the piece. NOT CENTERED.

What am I doing Wrong????
I dont know if this is the right area for posting if not Please point me in the directions... Thank you!