Hi,
Does everyone have to do the above?
i.e. just ran T1 then T2 & I now want to run T2 again,normally I would load in T1 in MDI then do a restart for NA002(T2) - Time consuming!!!!!!!!!
If not, what do you do instead - does the OCHG macro eliminate this?
I don't know if anyone is interested but I have written a macro so you don't have to call in the previous tool when you do a restart, you can have any tool in the spindle & just restart for any Tool Number!!!!
Jason
Results 1 to 2 of 2
-
04-19-2009, 12:16 AM #1
Registered
- Join Date
- Nov 2007
- Posts
- 9
Multus - Calling in previous tool before a restart
-
04-19-2009, 08:50 PM #2
Member
- Join Date
- Mar 2009
- Posts
- 1982
just a second. Do You mean, that Okuma part program restart feature doesn't works at this case?
Reply With QuoteSimilar Threads
-
Set up time on a Multus??
By j44snk in forum OkumaReplies: 23Last Post: 03-12-2009, 06:28 PM -
Each pass different than the previous
By gage1049 in forum DIY CNC Router Table MachinesReplies: 4Last Post: 10-22-2008, 09:47 AM -
should we by a multus????
By kennyayr in forum OkumaReplies: 1Last Post: 08-20-2008, 06:33 AM -
Calling a Tool up
By MBG in forum G-Code ProgramingReplies: 10Last Post: 04-30-2008, 03:04 AM -
g code for repeat the previous move
By woffler in forum G-Code ProgramingReplies: 6Last Post: 03-27-2008, 04:07 AM
Posting Permissions
