Has anyone used Fanuc's NC GUIDE or NC GUIDE PRO software?
Any feedback?
Has anyone used Fanuc's NC GUIDE or NC GUIDE PRO software?
Any feedback?
hello,
could you explain what this software do? i just know about Manual Guide i, it is one of fanuc programs for conversational programming
sting
You can see the simulation of a program created by you. It also has manual guide functions. Fanuc India has sent me a pdf file which describes this software. This is over 3 MB file, so I am not able to upload it here. Even the zipped version is not uploading. If you send me your personal mail ID, I will forward it to you.
hello,
Thanks for your concern, my mail is
[email protected]
thanks
please send me a copy of it. my email id is [email protected]
sent.
please send me a copy of it too. my email id is [email protected]
Thanks!
Sent.
If anybody has ever used it, please let me have a feedback regarding its ability in simulating a user-developed program.
hello,
Thanks for your concern, my mail is
[email protected],
thanks
cnc
Could also send me this file? I would much appriciate for sending this file at following email id:
[email protected]
I use NC Guide Pro on a daily basic, it's the only try Fanuc CNC simulator.
It is good for what i do - designing PMC's without the machine (can test and simulate it well).
I also get people sending me their NC programs they have issues with, good tool test out, and the graphics are ok.
It is a good learing tool too, when you hover over codes, it tells you what they are.
Manual Guide i is included.
What are your plans for it?
The Fanuc Support Center Team
www.fanuc-support.com
It's not very good for 3D work. 2D and 2.5D it's ok.
For 3D work i used vericut to test programs.
There are tooling forms on it.
Have you seen Manual Guide i? All NC Guide is, is a Fanuc CNC Sim on your PC and it has MGi Guide. It's very expensive for what it does, £2000 - £4000, depending on model.
The Fanuc Support Center Team
www.fanuc-support.com
I am under the impression that MGi is only for conversational part programming. It cannot show the toolpath/final shape of the workpiece, for a program created outside MGi. Pl clarify.
If MGi can show the simulation of an external program, what is the need for NC GUIDE, if program verification is the sole purpose?
Hello.
You can simulate any Fanuc program with it. Normal G-code, MGi code, macro b etc.
It will show tool paths and a 3d model for all of the above.
NC guide is used for more than program verification, it is a training aid for colleges to learn the Fanuc control, or to test out the effect of parameter changes etc.
Pro is to prove out PMC's - that is a good tool.
The Fanuc Support Center Team
www.fanuc-support.com
Here is MGi / NC Guide with ISO Code in it.
The Fanuc Support Center Team
www.fanuc-support.com
merhaba,
Kaygılarınız için teşekkürler, benim posta
[email protected]