Wondering if anybody out there is running a milltronics partner mill w/ centurion IV control dnc? I have recently purchased cad cam software for the machine and have finally figured out the software. I drew my part, posted it and fed it to the machine, but there is virtually no memory(10K) on the machine so it overloads it. A couple questions, what are the steps to get it to run DNC(I found the parameter #86, but thats all the further I got). I am now afraid that the baud rate of 1200 is going to be too slow to run DNC based on the length of time it takes to fill the 10K memory. Am I wrong? The other thought I had is there any way to add memory to the existing machine to load large files? The tape reader is junk so I think there is an open port. I am not a computer engineer so anybody with more smarts or experience please help me out.