Is anyone using this? Are there additional modules necessary for mastercam do do this? Excuse me if this is stupid, I am new to the whole thing, and trying to figure out what to buy.
Is anyone using this? Are there additional modules necessary for mastercam do do this? Excuse me if this is stupid, I am new to the whole thing, and trying to figure out what to buy.
There is not a software just for Plasma from mastercam ,but I do know some do use it for this by setting up the post for the right outputs.
Hope this helps
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
I know a shop that they are using a mill level 2 package to program a waterjet machine, they post a mill prog and edit a few lines and bingo, they were working on editing a post that wouldnt need modified even though it was a quick process, I gotta think a plasma cutter should be similar but maybe not I never seen one that was cnc.Just my .02
Mcam forum member #1415
I talked to our laser/plasma guys at work today, its all in the
post. Just like mold said, edit the post properly and
your off and running.
PEACE
Like Mold100 stated I have programmed Water Jets in the past they are cool.
But it was all in the post .I made some change and all was good.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .