Hi Scott,
I know you've been busy but....
Have you got anywhere with any plans ref plotting enhancements discussed ages ago?
Specifically some selectable display buttons so NCPlot runs through code as a cnc does ie
If the M01 button is clicked, NCPlot stops at every M01 in the program.
If / (block delete) is on, NCPlot ignores that part of the program.
Similarly if there is a M00, again NCPlot stops.
Lastly, we discussed the displaying of H +D offset values together with its related tool. So we know when backplotting that the correct tool offsetts are called.
If I remember correctly, you said that it would be difficult to do because a look-up table would be involved???
Well, as a thought, now you have the Tool List display, could you not do something with this?
Under the Tool List is a lot of empty space (for the depth of the monitor) depending upon how many tools are used in the program.
So, could you use some of the space to have the Tool List displayed as
Tool 1
H1 D1
Tool 2
H2 D2
Tool 3
H3 D (Blank as offset not called in the prog)
etc
Keep up the great work!
Cheers,
Terry