Originally Posted by
fenix728
hi, guys can anyone please tellme how to set the auto save comand in master cam x3 i know for mastercam x it was Alt +A but it does not work the same with mastercam x3 thankyou for your help. i would appreciate any kind of input on that subject thanks .
If I remember the last time I touched X2 there should be a Configurations Setting. In there you will see a list on the left side, but I am not sure which one it is under.
I hope this helps a little.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com