Hey Guys,
I had the same problem as well about 5 weeks ago after receiving a replacement one from Aoran.
VERY good feed back service from them and all my emails were answered in a few minutes. He must not sleep. :-)
I had done a full reset and still had the same problem with the motor running at 600 revs and then smoking.
I then laboriously went through the manual changing settings one by one of the ones I thought would make it spin faster through torque curves etc but as it turned out it was a simple setting on (I think) PD025.
I will confirm this when I get home as I haven't got the manual with me at the moment.
You need to change it from 0 to a 1.
I set this then everything went very well.
Now all I have to do is find out how to wire it up through the computer which, if my readings on the forums is right, will be very difficult due to the Chinese engineers not implementing the ModBus properly.
If anyone knows about this then I am all ears (or eyes here)
Rich.
Update.
It is PD025 and the setting is set to 1 for " Frequency Track Start "
That should get you back on board with the motor overheating after you do a "reset" on PD013 (set to 08 )
I am not completely useless.......I can always serve as a BAD example.