512,420 active members
4,275 visitors online
Register for free
Login
Results 1 to 5 of 5
  1. #1
    Registered
    Join Date
    Feb 2009
    Posts
    495

    Digital Machinist?

    I was thinking about subscribing to Digital Machinist as they advertise it as being about CNC. I am primarily a wood router kinda CNC'er, but would like to do some light aluminum sometime.

    I was wondering if anyone else subscribes, and if so, what they think of the magazine. How relevant are the articles to routing? Are there any back issues of interest? I did look at their website, but I really can't tell from that.
    TIA,

  2. #2
    Registered
    Join Date
    Feb 2005
    Posts
    791
    Well I dont know much about the magazine but it does have a free copy option right on the website you can sign up for. I did and I will see what the magazine is like.

  3. #3
    Community Moderator ger21's Avatar
    Join Date
    Mar 2003
    Posts
    34659
    Go to your local Barnes and Noble and read it. Check out a few issues, then, if you like it, subscribe.
    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

  4. #4
    Registered
    Join Date
    Feb 2005
    Posts
    791
    I hate going into books stores too look at/for magazines. they are always rearranging the magazines, so they are never in the same place or even the same section.

  5. #5
    Registered
    Join Date
    Feb 2009
    Posts
    495
    My local B&N is narrow minded, I guess. They don't seem to carry it. From the lack of response of subscribers, though, I guess not many do. I did request a freebie.

Similar Threads

  1. Digital Version of Digital Machinist
    By castiron43 in forum Digital Machinist
    Replies: 35
    Last Post: 08-02-2013, 12:04 PM
  2. Looking for CNC machinist/manual machinist in detroit metro area
    By Runner4404spd in forum Employment Opportunity
    Replies: 4
    Last Post: 11-12-2007, 07:11 PM
  3. Go Dial or Go Digital ?
    By thkoutsidthebox in forum Calibration / Measurement
    Replies: 14
    Last Post: 07-26-2007, 08:27 PM
  4. Digital Machinist Magazine
    By 307startup in forum Community Club House
    Replies: 4
    Last Post: 02-11-2007, 06:29 AM
  5. DIY digital readout
    By kong in forum General CNC Machine Related Electronics
    Replies: 21
    Last Post: 02-08-2005, 11:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •