Not sure what setting I have changed but now when running a g81 or g83 file the head retracts to the z home position between each hole drilled. What do i need to change?
Thread: G81 RETRACT HIEGHT?
Results 1 to 2 of 2
-
05-14-2009, 10:19 PM #1
Registered
- Join Date
- Aug 2004
- Posts
- 309
G81 RETRACT HIEGHT?
-
05-14-2009, 10:27 PM #2
Gold Member
- Join Date
- Jul 2005
- Posts
- 12177
All the way to machine home?
The codes and Settings that are involved in the retraction for canned cycles are:
G98 Initial Point Return so it comes back to the Z position immediately before the canned cycle.
G99 R Plane Return so it comes out to whatever your are value is.
Setting 22 Canned Cycle Delta Z controls G73 retraction but I have no idea if it affects other drilling or boring canned cycles.
Setting 52 G83 Retract Above R but I don't know if this affects G81.An open mind is a virtue...so long as all the common sense has not leaked out.
Reply With QuoteSimilar Threads
-
Help needed Mazatrol M+ tool hieght
By mt92 in forum Mazak, Mitsubishi, MazatrolReplies: 5Last Post: 03-31-2009, 09:19 PM -
G76 Questions bore with retract
By kojack in forum Haas MillsReplies: 1Last Post: 12-21-2008, 02:38 AM -
retract and feed
By beartrax in forum MastercamReplies: 3Last Post: 08-11-2008, 04:28 PM -
Eia Tool Hieght Offset On Nexus 640
By anvil99 in forum Mazak, Mitsubishi, MazatrolReplies: 1Last Post: 03-23-2007, 05:55 AM -
Retract Height
By Sanghera in forum SheetCamReplies: 1Last Post: 05-30-2005, 05:52 AM
Posting Permissions
