Will all my settings remain in tact if I install the latest version? I'm running 1.84 now and want to upgrade to ver 3 but I don't want to have to set up everything all over again - inputs, motor tuning, etc.
Thanks.
Will all my settings remain in tact if I install the latest version? I'm running 1.84 now and want to upgrade to ver 3 but I don't want to have to set up everything all over again - inputs, motor tuning, etc.
Thanks.
yes all setting will be intact
Always a good idea to back up your .xml just in case.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I upgraded Jan of 2008. As far as I know I have no issues. Should I leave well enough alone?
Nick http://www.nixstuff.com
http://www.youtube.com/watch?v=jTu7wicVCmQ
If everything works for you, then I wouldn't upgrade. Only upgrade if you need newer features, or you have problems.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)