I checked it out and think all the elements are OK.
Now I will set the Vref again and will control of it more often.
How to do so: If any axis is stopped (error) Mach3 stop too?
Regards,
Andrey
I checked it out and think all the elements are OK.
Now I will set the Vref again and will control of it more often.
How to do so: If any axis is stopped (error) Mach3 stop too?
Regards,
Andrey
The system should be wired so, if there is an axis drive error, Mach3 should go into EMG stop and the drives should get de-energized. It all depends on your EMG stop circuit wiring and how you want drive errors to be treated in your system. Sometimes you should start the program from the beginning after a stop, it depends on which part of the program is was running at the time, most of the time the part being machined gets ruined.
Regards,
kreutz