[Ecmdrw5]

I just got a new NH-4000 and i'm have trouble getting the tool setter to work. I've pulled the G324 program from the older NH-4000 and when I hit the cycle start it comes up with Set.ErrorSP.Position Z. I tried to call mori twice now and it says all ports busy. Any ideas?

[Scottyb]

Here is the program in our machine that works well for us.
There are parameters to be set, Tool to be measured, and off sets for large tools.
Hope this helps.
Scott Bridges
%
O1234(TOOL LENGTH MEASURE)

(SET #500=TOOL TO BE MEASURED)
IF[#500EQ0]GOTO3000
GOTO500

N500
T#500
M6
M19
M00(SET VARIABLES BELOW)

(SET #501=X AXIS SHIFT)
(SET #502=Y AXIS SHIFT)

G324X#501Y#502H#148R3

#500=0
#501=0
#502=0

M30


N3000
#3000=1(TOOL NUMBER NOT SET)
%