We have a Mori MV-40B with Fanuc MF-M4 controls.
we are experiencing two seperate problems.
(1) - When T1 is in the machine and we run a program that uses T1 we get an EX0202 SPINDLE TOOL COMMANDED error. We have been getting around this by having the machine pick up T2, then starting the programs.
(2) - We are only able to use T1, T2, and T4 - if we try to use any other Tool we get an EX0201 IMPROPER TOOL COMMAND error. We have not been able to figure this out.
I appreciate you taking the time to help in this matter.