I am looking at used VF-3s... Is there anyway to display the machines actual spindle, and motion timers? The only timers that I know of are the ones at "CURNT COMDS" --> "PAGE DOWN"
Thanks,
Matt N.
I am looking at used VF-3s... Is there anyway to display the machines actual spindle, and motion timers? The only timers that I know of are the ones at "CURNT COMDS" --> "PAGE DOWN"
Thanks,
Matt N.
I think the true time is visible in Debug Mode.
This should work:
To get into debug mode go to SETTING 7 "PARAMETER LOCK" and set to OFF.
Go to ALARM page and type DEBUG and press "write" button.
You are now in DEBUG mode.
Now go to the Diagnostics screen and page up or down and you should see some times displayed.
To exit debug mode, type DEBUG once more in ALARM page.
An open mind is a virtue...so long as all the common sense has not leaked out.
when your in the debug mode go to the position screen and page down to the raw data page will give the times.
Thanks everyone
This is what I have been looking for!
THANKS for this post.
_____________
teamjnz