Been awhile, been busy makin parts...until today.
Machine is a 95 VMC 15
Y axis was acting a bit weird, thought the heat was getting to it, so opened the cabinet to get some air to the boards. Never even had a chance to make any chips, as I would get a Y axis resolver fault/over temp fault. RE-set a few times, never would take.
So I thought I would have a look see at the Y axis, and the motor is blistering hot, cannot holod my hand on the case for more than a few seconds.
So are my fears that the motor is shot going to come true, or is their an somewhat easy fix?
Thanks,
Smitty