[Troncatore]

Hello to ALL
I'm having trouble setting V25 Milling...I solved partially but I would like to know that please let me know what this message means: Invalid collision pair: tool, stock. Does millimeters are usable on machine definition for the axes parameters definition?
Regards

[Louis Roy]

I had the same problem when I first installed BBC on my computer. The simulations worked fine for a couple of days, probably because they were tiny. Once I tried to simulate a larger part program the exact same error you described came up and the simulator stoppped working, every time I tried to run the sim same error message. To fix this I had to get a better computer, one with the graphics card seperate from the mother board. It was all spelled out in the system requirements, I just didn't know what it meant until I had to figure it out. Good luck. Lou

[Troncatore]

Thanks Lou..
Also I fixed it with a new installation and enlarging at maximum the table displacement...! Often it means: " the cutter collides with the structure".
Thanks for Your help