506,373 active members
2,724 visitors online
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Will mastercam do Mill/turn programing???
Results 1 to 3 of 3
  1. #1
    Registered
    Join Date
    Aug 2004
    Posts
    217

    Will mastercam do Mill/turn programing???

    Hi guys

    I have a doosan 2000SY with a Fanuc 18i-TB control, this machine has X Y Z C1 C2 B axis. I asked around afew differant forums an have been told that Featurecam is the best an easiest program to use for this machine.


    Will mastercam X4 support this type of 6 axis machine???
    Is there a post processor for a 2007 Daewoo puma 2000SY(fanuc 18i-TB)???


    Could some of you guys give me your advise on this subject.


    Thanks
    Mike

  2. #2
    Registered
    Join Date
    Mar 2005
    Posts
    988
    Not sure where in Canada you are but you need to get a hold of In-House Solutions (the same outfit that runs the eMastercam website). They have been writing many of the multi-task posts and multi spindle machines for quite some time. In-House Solutions are around a couple places in Ontario and a place in BC I think. If they don't have one, they can write one.
    It's just a part..... cutter still goes round and round....

  3. #3
    Registered
    Join Date
    Feb 2008
    Posts
    7
    Mastercam will work with the puma. I have the same machine. You can down load a post on emastercam.com its free and works well. Good luck

Similar Threads

  1. Programing a parabola on mill
    By roger_e in forum General CNC (Mill / Lathe) Control Software (NC)
    Replies: 8
    Last Post: 07-22-2012, 07:23 AM
  2. NEDD HELP PROGRAMING TO CUT A THREAD ON A CNC MILL
    By malirami in forum Machinist Feedback
    Replies: 16
    Last Post: 05-08-2009, 03:46 PM
  3. turn on mastercam direct
    By Korellibopper in forum Mastercam
    Replies: 1
    Last Post: 03-31-2008, 12:33 PM
  4. Cin Turn turn/mill
    By Robert Timby in forum General CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 01-25-2007, 02:12 AM
  5. Mastercam X and multispindle mill-turn machines?
    By nemat0de in forum Mastercam
    Replies: 1
    Last Post: 01-25-2005, 09:37 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •