Has Anyone used featurecam with a gangtool lathe? Any pro's or con's? My lathe has C Axis and live tooling. I want to start out with the basic 2 axis turn module and then step up to a turn/mill module down the road.

I'm currently demo-ing BobCad, OneCNC, and Featurecam. Featurecam seems to be the best but also the most expensive.

Bobcad doesn't really look like an option as there is no live tooling or c axis support at all. Onecnc was looking pretty good till I demo-ed Featurecam.

Any feedback or advice would be greatly appreciated. Just want to make sure I get the right CadCam software the first time and also make sure it woks well on the gang tool lathe.

Best regards,
Dennis