586,115 active members*
3,432 visitors online*
Register for free
Login

Thread: crt screen on accurite millpower controls going out

Results 1 to 4 of 4
  1. 08-10-2007, 12:39 AM #1
    piketool
    piketool is offline Registered
    Join Date
    Aug 2007
    Posts
    3

    crt screen on accurite millpower controls going out

    I have a problem with the the screen going dark about 10 minutes after booting up.Is there a board that can be replaced to fix this?Has anyone else experienced this.Thanks in advance.
    Reply With Quote Reply With Quote
  2. 08-10-2007, 12:48 AM #2
    outctrl
    outctrl is offline Registered
    Join Date
    Aug 2007
    Posts
    16

    accurite

    pike,
    does it just blank off or act like you turned it off. there was firmware problems with some models about 2 years ago.
    Reply With Quote Reply With Quote
  3. 08-10-2007, 11:45 AM #3
    piketool
    piketool is offline Registered
    Join Date
    Aug 2007
    Posts
    3
    No I can still operate it but can;t see digital scales or soft key words.Thanks
    Reply With Quote Reply With Quote
  4. 07-02-2009, 08:48 PM #4
    markj
    markj is offline Registered
    Join Date
    Jun 2009
    Posts
    4
    We have same problem about 10 min. after start up . We were told hit it hard on top of box this works almost all the time. ( was told by accu-rite repair to do this ) we are now trying to get new box they have tryed to fix it 2 time no luck
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Accu-rite MillPower
    By ddwiers in forum Bridgeport / Hardinge Mills
    Replies: 12
    Last Post: 12-20-2011, 03:24 AM
  2. Homemade Screen Printer/Silk Screen
    By Sbthomas13 in forum Machine Created Art
    Replies: 20
    Last Post: 02-14-2009, 01:35 AM
  3. Jog Controls
    By dafowfidy in forum Mach Mill
    Replies: 2
    Last Post: 03-21-2007, 10:01 PM
  4. Most Accurite CNC
    By ajl6549 in forum Uncategorised MetalWorking Machines
    Replies: 2
    Last Post: 03-07-2007, 03:55 AM
  5. Controls
    By Chuck Pool in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 7
    Last Post: 02-23-2006, 06:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules