Hello,
Can somebody point me to where I can get outside jaws for holding large diameter stock, to my EMCO PC Turn 50, and how do I figure out the size I need.
Thank you in advance
Runar
Hello,
Can somebody point me to where I can get outside jaws for holding large diameter stock, to my EMCO PC Turn 50, and how do I figure out the size I need.
Thank you in advance
Runar
Perhaps it it easyar and cheaper to build a new chuck and mount it on the spindle
mfg:Friedemann
hello friends. i bougth an used emco pc turn 50, i have a compatible computer, but the installation disc are broken, anybony can help me to find the correct software to make work my turn... thaks ...
Yes I have software for this machine Emco pc Turn 55 with WINCAM
send me a email
Gr. jord
thank you very much Gr. Jord
my e mail is [email protected]
I need it so much
thank you again
I am not a computer guy, I dont't know how to send you the files
Gr. Jord
I bought the emco PC turn compete with computer and so, I don't even know how to get this machine to work?
I need some one in the Netherlands to help me out to get it working with the software PC turn, Do you Know any one that help me out?
Jord