I am looking for a Fanuc 11m keypad, for a 1982-88 not sure of the year, Supermax, Max 1. The key pad is at the top right of the console, it has the numbers and letters.
See picture.
Also I have to use an orgining program to set X0Y0.
I would like to put the X0Y0 in the work offsets page.
G54, G55, G56, ect... thanks.
Results 1 to 3 of 3
-
07-15-2009, 12:56 AM #1
Registered
- Join Date
- Jul 2009
- Posts
- 22
NEED FANUC 11M KEYPAD SUPER MAX 1982 VMC
-
07-15-2009, 06:36 PM #2
Registered
- Join Date
- Jan 2006
- Posts
- 59
Keypad
Around the keypad/membrane is a frame. Remove the screws and gently "pop" the frame off. If i remember correctly the part number in the lower right corner.
FYI,The membrane has an adhesive back. So when you get the new one it will be a little bit of a task to remove the old one.
RRL
:wave:
-
07-15-2009, 08:58 PM #3
Registered
- Join Date
- Jun 2005
- Posts
- 232
If your just looking for the key sheet yoy can buy them from.
CNC Electronics ,phone 434-971-1689Tim
Reply With QuoteSimilar Threads
-
1982 fanuc CNC CK2
By mark oz in forum DNC Problems and SolutionsReplies: 2Last Post: 01-30-2009, 12:09 PM -
1982 fanuc 6m control (Enshu) 401 servo error
By Rob Lacy in forum FanucReplies: 7Last Post: 10-26-2008, 08:51 PM -
Fanuc O-M keypad cover replacement
By HapSmo19 in forum Want To Buy...Need help!Replies: 0Last Post: 08-06-2008, 05:42 PM -
Keypad trouble, Fanuc 10M
By the professor in forum FanucReplies: 0Last Post: 09-17-2007, 08:07 PM -
Fanuc OT Keypad replacement
By thardy in forum FanucReplies: 3Last Post: 11-09-2006, 05:39 AM
Posting Permissions
