Mach 3 Crashing PC
I have not fired up my mini mill for a couple weeks, but I need to engrave some replacement number chips for a club I help run. Anyway, turned on the PC and started my controller the other day, and I have been dinking with it off and on for about a week now.
Nothing seems to be wrong with the PC. All other software works. AVAST says it has a clean bill of health. Memory tests are ok, but when I start Mach 3 the PC reboots. Not always instantly, but everytime. Usually prety quickly.
Following diagnostics were done.
Memory test
Re-install Mach 3
Install latest version of Mach 3
Unplug controller from LPT port
Start Mach 3 with different setup file.
Still crashes. I can run multiple other aps... no crash.
HELP!!!
I'll try another PC when I have more time to set one up, but this one is driving me nuts.
Bob La Londe
http://www.YumaBassMan.com