586,036 active members*
3,576 visitors online*
Register for free
Login

Thread: re-surfacing the cnc table top

Results 1 to 1 of 1
  1. 07-22-2009, 03:19 AM #1
    woodman08
    woodman08 is offline Member
    Join Date
    Oct 2007
    Posts
    1022

    re-surfacing the cnc table top

    It was time again to re-surface or level out the table top .This time i took it down 1/8 inch ,everything went well it took about 1.15 hrs ,i could have ramped up the speed but i kept the router amps about 8.78 to 9.10 amps and used a 1.50 carbide bottoming bit with a 45% step over
    Table looks good now ,all the nail and screw marks are almost gone but its flat and smooth


    [ame="http://www.youtube.com/watch?v=797cvxfdDK4"]YouTube - cnc table re-surfacing[/ame]
    Attached Thumbnails Attached Thumbnails net1.jpg  
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Surfacing help!
    By Thorpydo in forum MetalWork Discussion
    Replies: 2
    Last Post: 04-23-2009, 06:11 PM
  2. Surfacing help!
    By Thorpydo in forum Benchtop Machines
    Replies: 14
    Last Post: 04-21-2009, 05:53 PM
  3. Surfacing
    By SyilAmerica in forum Syil Products
    Replies: 2
    Last Post: 12-17-2007, 06:38 PM
  4. G-Code table surfacing program?
    By Imagineering in forum Parametric Programing
    Replies: 10
    Last Post: 07-27-2005, 04:03 AM
  5. surfacing help
    By lt paul in forum Rhino 3D
    Replies: 2
    Last Post: 07-16-2004, 03:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules