[gamila]

Hello all,

My Fadal VMC-20 goes into alarm when tapping. Forward is ok, when it tries to reverse the spindle, it alarms. I tried swapping relay K4 with K3 and checked fuse F3. Any help would be greatly appreciated!

Thank you in advance!
Gary
(gamila)

[denmar]

Is a rigit tap machine?.. check parameters (setp) orient 5, rpm10,change the
rigid tap factor. Check connection at controler card and inverter.

[gamila]

It is not rigid tap.
Gary

[denmar]

at the kboard type
mdi-enter
S900m4-enter
the spindle should go ON REVERSE
what's the program block for the tappyng cycle?
are you using a tapmatic head?

[gamila]

Have tried that, the machine alarms and has to be restarted. I am not using a Tapmatic Head, am using a tension - compression holder.

[denmar]

make shure spindle pot is at 100%
check orient switch
check belts tension
check air press
and power to inverter, 230

[Neal]

If the spindle won't reverse under any circumstance, check Fuse F3, Relays K9 and
K4 on the 1100-2 board. Also check for loose wires or terminals.

Neal

[gamila]

You guys are the greatest!!!
It was relay K-9 (the dirty dog!).
Thanks again!

gamila
:rainfro:

[JoBwan]

If the spindle won't reverse under any circumstance, check Fuse F3, Relays K9 and
K4 on the 1100-2 board. Also check for loose wires or terminals.

Neal

You guys are the greatest!!!
It was relay K-9 (the dirty dog!).
Thanks again!

gamila
:rainfro:

Guys,
Great info!!!! Glad to see you are back up and running!:cheers: