I am not sure where t put this topic, so I will stick it here unless the mods disagree.
Anyway, I am looking to etch my company logo into panes of float glass and borosilicate glass, which is tougher and much more heat resistant than float glass. The logo would be about 1"x2" tops. I also need to etch or scribe a grid into the surface of the glass that will be just barely visible against a frosted glass surface. I will use this machine 5 days a week, 10 times a day tops, always with the same or similar programing. My questions are:
A.) What machine would you recomend for somone on a tight budget to do tis job?
B.) What kind of end mills will I need?
I have been eyeing a maxnc 15 system on ebay for 1200 bucks, if that would dothe trick I would be thrilled.