Hello...
I know I've seen them but can't find the site now.. In anycase looking to adapt the .5" output shaft of one of my servo motors to a female coupler (that goes into a planetary)..
In anycase I've seen them around, sorta like a collet with a split so it can be compressed and such..
In anycase I'm sure someone can direct.. Basicly want to adapt a .5 shaft to a .75 clamping coupler and clamp them all together.
Perhaps not the best soloution but want to be prepaired to do it this way as I don't think I'm going to be luckey enough to find a planetary gear head with a .5" input this time around. Most seem bigger then that these days.
b.