586,105 active members*
3,136 visitors online*
Register for free
Login

Thread: Turbocnc

Results 1 to 2 of 2
  1. 08-07-2009, 02:31 AM #1
    valmet58
    valmet58 is offline Registered
    Join Date
    Nov 2003
    Posts
    93

    Turbocnc

    Anybody out there using turbocnc to drive a lathe converted to cnc?
    Andy
    Reply With Quote Reply With Quote
  2. 08-07-2009, 02:15 PM #2
    Bubba
    Bubba is offline Gold Member
    Join Date
    Mar 2004
    Posts
    1806
    Dave K. the original writer of Turbocnc uses one daily and has written it up on the DAKENG site http://www.dakeng.com/lathe.html In some discussions recently, he said he had pretty well worn the way and has not replaced them with linear bearings!
    Art
    AKA Country Bubba (Older Than Dirt)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Why not Turbocnc
    By rlwoodjr in forum DIY CNC Router Table Machines
    Replies: 18
    Last Post: 07-15-2009, 04:58 AM
  2. Trying to set up TurboCNC
    By bob^ in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 8
    Last Post: 11-25-2008, 07:38 PM
  3. Help with Turbocnc
    By aghobby in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 4
    Last Post: 07-10-2004, 02:44 PM
  4. Need help with Turbocnc!
    By smitty in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 5
    Last Post: 04-28-2003, 05:18 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules