I have a Bridgeport Series 1 EZ-Trak DX. My machine has a flash drive and a floppy. I got an error msg saying the back up battery is dead. It won't boot or allow me into the setup screen. I understand it to be ideal to have copied all the cmos info but, it was too late. Can anyone send the settings to me? Thanks for the other post on this subject. Great info.
[email protected]
Thread: EZ-Trak DX with a dead battery!
Results 1 to 3 of 3
-
08-09-2009, 12:59 AM #1
Registered
- Join Date
- Aug 2009
- Posts
- 1
EZ-Trak DX with a dead battery!
-
08-09-2009, 01:02 AM #2
Registered
- Join Date
- Feb 2007
- Posts
- 664
replace the battery
hold del key down when booting
when in bios goto save settings and exit
this worked for me once
-
08-10-2009, 02:03 AM #3
Moderator
- Join Date
- Nov 2004
- Posts
- 3028
There were MANY different mother boards used all with different CMOS settings.
The basics is to set up time. date, type of floppy, turn off keyboard test and set the flash drive up correctly. A flash card and a DISK on a CHIP require the C dive to be set to none.
George(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
OSP5000L battery dead on Okuma LR15 Turning Center
By mohammadali in forum OkumaReplies: 13Last Post: 01-20-2010, 03:24 AM -
Fanuc 0 dead screen ... dead control?
By Noss Machine in forum FanucReplies: 4Last Post: 01-24-2009, 04:03 PM -
battery alm
By Drye-123 in forum FanucReplies: 4Last Post: 12-18-2008, 03:26 PM -
CPU dead battery
By LT1TRUCK in forum Computers / Desktops / NetworkingReplies: 2Last Post: 09-10-2007, 12:47 PM -
Help! Dead Series 1 R2E3 battery, need jumper cable?
By Bill Gillen in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-12-2006, 11:24 PM
Posting Permissions
