Hi everyone,
I got the 4-axis board and motor drivers from sunrom here in India.
I have attached two images 1) 4-axis board 2) stepper motor driver for 1 motor, I have four of them (4 boards and 4 motors), Also I have attached the schematics of each one
I was able to complete all the connections on my own, however I am able to control the motors partially through PC.
Driver Board ..........4-axis Board
EN.........................EN
DIR........................DIR
CLK......................STEP
GND......................GND
But cannot understand where should I connect
HOME
HALF/FULL
RST
OSC
How to include Limit Switch And E stop
I have bipolar motor with 4 wires 12v
I need help ....please reply asap