hi i hope this is the right place, in my new job they have a conventional grinding machine and the boss said i am suppose to grind and make my own tools out of carbide if i am to keep my job, as cnc set up man , i am used to receive the tools ready for their application on the particular job which is a bad habit, because i have a hard time to provide my own tools does anyone has manual or can refer me to a site or book about how to resharp and make tools like ID grooving boring bar , face grooving boring bar i am smart and handy but i lack experience and theory about the geometry of tools, so i am open and thankful for any advice at all thanks a lot. and i want to know if is posible to resharp a drill on a grinding machine if so, how to make a fixture to get the "perfect sharp thank you for helping me keep my job