I have started my first Home built CNC router. I have most of the MDF pieces cut, just need to finish drilling holes. Hope to start puting things together this weekend.
HobbyCNC EZ Driver board is built, and tested. I have set up an older PC with EMC2 Machine Controller, but my latency is terible. I am going to install a video card in hopes that disabling the onboard video card will increase performance. Guess all that soldering as a kid finally paid off!
I also successfully set up two scrapped ATX power supplies in series to give me 24V-18Amps. I may add a 3rd, but I am woried that it will bring me above the 36V Max input voltage for the board. Any suggestions?
I am so thankful for finding a great forum!