Dear All,
As i could get a place to put New thread, hence using "Reply" field in place of New Thread - Pl excuse me
Machine Details : Magnum High speed Chiron-Wierke
D-78532 TUTTLINGEN
Nr. 457-07 Year 1997 with Siemens 810 GA3
This machine was nnot in use for 1 year, when we tried to switch we got Error "PLC STOP", then as per the standard procedure we loaded PLC through our old back up, everything got loaded without any error but finally when we switch ON the machine again we get "PLC Stop"
We repeated few times but still PLC Stop
We feel that our PLC nackup is not OK
a) Can any of u please send me PLC of this machine
b) Apart from this any other advice if u can give me
Best Regards,
Pl reply to
[email protected]
M. Rishikesh