586,112 active members*
2,999 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > Souce for NEMA 42 stepper motor?

Thread: Souce for NEMA 42 stepper motor?

Results 1 to 3 of 3
  1. 03-03-2005, 07:36 PM #1
    Mueller
    Mueller is offline Registered
    Join Date
    Feb 2005
    Posts
    24

    Question Souce for NEMA 42 stepper motor?

    I need to replace an older Sigma stepper motor that is rusted due to poor protection while moving the machine (Z-axis)

    The stepper is from a Series 1 Bridgeport (ex-boss controls, now Geckos and turboCNC for control)

    I've been qouted $375 for a used Sigma motor (~1000 oz torque)

    I found a brand new motor for $321 from Sanyo Denki being sold by mendonet(?), but I cannot figure out if he is still in business or not.

    Flashcut CNC has a motor for close to $600 with specs pretty darn close to the above motor.

    Thanks,
    Reply With Quote Reply With Quote
  2. 03-03-2005, 11:32 PM #2
    Mac T. Knife
    Mac T. Knife is offline Registered
    Join Date
    Jan 2005
    Posts
    66
    And then there's Ebay,,, Here's two, with encoders http://cgi.ebay.com/ws/eBayISAPI.dll...sPageName=WDVW
    Reply With Quote Reply With Quote
  3. 03-07-2005, 02:59 AM #3
    witold
    witold is offline *Registered User*
    Join Date
    Feb 2004
    Posts
    9
    try www.nanotec.com . I am very happy with their steppers
    witold
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. stepper motor load resistor and figuring out phases?
    By drtuto in forum CNC Machine Related Electronics
    Replies: 7
    Last Post: 03-19-2005, 09:53 PM
  2. Stepper Motor Selection
    By dberndt in forum Stepper Motors / Drives
    Replies: 7
    Last Post: 12-06-2004, 01:50 PM
  3. Not good for a stepper motor?
    By FLUTE HEAD in forum Stepper Motors / Drives
    Replies: 4
    Last Post: 12-02-2004, 06:31 AM
  4. Which stepper motor should I buy
    By Graham S in forum FAQ of DIY CNC Machine Building
    Replies: 0
    Last Post: 08-27-2004, 11:58 AM
  5. Motor selection advise needed? Servo or Stepper
    By Beezer in forum DIY CNC Router Table Machines
    Replies: 1
    Last Post: 03-21-2004, 07:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules