Originally Posted by
Mangus
Am I reading/seeing that right - that the ZTO takes up 2+" of my 5.5" of Z travel? Everything else seems well thought out, but that seems like a silly limitation for a ZTO.
Hi,
My ZTO only takes up about 1.5" , My router only has a 5" Z travel and I can zero a bit on top of a 1.75" blank sitting on a .75" vacuum form with my bit sticking out of the router 1.9375" with out any problems. Hope this helps- Robbie
Robbie
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)