Originally posted by Scott_bob
I have updated the charts here for BPT performance.
Check it out! page 3...
Anyone else surprised by the performance of the Yasnak?
Sincerely,
Scott_bob
I am a little. I knew it would be very good, but geez!
Here's a re-post of my results (from the Fadal thread)
This Just In...
(Post #49 )
While I won't share with you the results of the BPT test on my 2000 model HAAS, (it was pretty bad), my 2002 model ran it in 6:04, with the display set to the Alarm page so no resources would be wasted in displaying the code as it executes. (This has been an issue for me in the past on other controllers.) Then, for pewps and chuckles, I ran it in Prog Dislpay mode, so it displayed the code as it ran, and it ran in 6:00. Go figure.
This is a VF3, 40 tool side mount turret, without HSM. (There's prolly about 300-400 pounds of fixturing on the table, not sure if that will affect anything)
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)