[PaioX]

Hello,
I've a LC1280 with 80W lamp bought from Wklaser and I'm wondering to upgrade it with a more powerfull laser lamp. I know that I will change the power supply and probably modify the machine so the lamp can fit.
Did you know any site that sell laser lamp/power supply?How much can I improve Watts?150W?200W?
Many thanks and sorry for my english

Paride

[zax15uk]

You could upgrade to a 120W or perhaps 150W, but often the solution is to use 2 tubes and combining optics. I would suggest to look at the RF excited lasers, you would get better performance and life - but of course the cost if higher.

Zax.

[SkipW]

Paride,

Email wklaser.com They should be able to fix you up with a more powerful tube and matching power supply, and they can tell you if anything else is needed. Also check ebay.

Skip

[hpc laser u.k]

Paride,
You can do this no problem,
Look at changing to 120 w and power supply,
Make sure you have a good chiller.
Also ask about the 10,000 hour 150w tubes I am trialling these they will cut 3mm acrylic at 5.5 mtrs per min:banana:
Fastest I,ve seen for a while
Thanks Chris

[PaioX]

Paride,
You can do this no problem,
Look at changing to 120 w and power supply,
Make sure you have a good chiller.
Also ask about the 10,000 hour 150w tubes I am trialling these they will cut 3mm acrylic at 5.5 mtrs per min:banana:
Fastest I,ve seen for a while
Thanks Chris

I've asked Wklaser for more powerfull tube and the suggested me the 100W tube because 130W could cause some problems (why?!).
Can you tell me where I can find 150W tube and supply?!What machine did you have and how works these tubes?!
Many thanks

Paride