586,347 active members*
3,482 visitors online*
Register for free
Login

Thread: FANUC 9M, it's HANG.

Results 1 to 2 of 2
  1. 10-12-2009, 04:40 AM #1
    ning
    ning is offline Junior Member
    Join Date
    Aug 2005
    Posts
    7

    Unhappy FANUC 9M, it's HANG.

    I have a problem with
    OKK MACHINING CENTER
    MODEL : MHA-800 NC/TC
    CONTROLLER : FANUC 9M

    When system boot
    BUBBLE#1:24
    BUBBLE#2:24
    BUBBLE#3:24
    BUBBLE#4:0
    RAM TEST : PASS
    LOAD BLD : END
    SYS NAME : M913C63822.....
    LOAD SYS : END
    RAM TEST (A) : PASS
    LOAD SYS (A) : END
    SYS NAME : PC001 *10
    RAM TEST (G) : ERROR
    display stay hold, it's HANG.
    How to troubleshooting I don't have any manual , what board is defective?
    Reply With Quote Reply With Quote
  2. 10-12-2009, 02:46 PM #2
    memoryman
    memoryman is offline Registered
    Join Date
    Apr 2009
    Posts
    1379
    is there more info showing after :RAM TEST (G) : ERROR ? try pressing 'C'.
    My manual says that the problem is in board 01P04.
    Bill
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mazatrol PC Fusion 640 Hang
    By flomatic in forum Mazak, Mitsubishi, Mazatrol
    Replies: 20
    Last Post: 05-25-2021, 12:31 AM
  2. Need Help on Monitor Hang
    By flomatic in forum Mazak, Mitsubishi, Mazatrol
    Replies: 16
    Last Post: 01-20-2020, 05:16 AM
  3. Fanuc system 9 loading "hang"
    By waterfall in forum Fanuc
    Replies: 19
    Last Post: 07-26-2017, 02:03 PM
  4. Want to hang from v2xt
    By v488 in forum Bridgeport / Hardinge Mills
    Replies: 20
    Last Post: 04-18-2007, 06:21 PM
  5. Post help hang up?
    By nervis1 in forum Post Processors for MC
    Replies: 6
    Last Post: 01-26-2007, 10:20 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules