[csmoak25]

Burr has been helping me, I have created several drawings using BOB Art and tried embossing and cutting in the Z level finish mode, howerver all it does is cut a 2d design, the outside line and inside but it doesnt remove the material around the object. I can use the slice planer mode with no problems, but the finish and rough mode is killing me. I have the training CDs and have watched very carefully and I believe I am following all the steps. If anyone would help me I have Teamviewer on my computer and you could download it and get on my computer and try to create the 3d emboss and see if its just me or there is something wrong. When I compute the tool path in the Z level finish you can look at it and tell there is not enough of ity there
I have zipped two file you can look at, if anyone can help please call me at 229-251-7552 Carey

[BurrMan]

Hey csmoak25,
Please see the response here:

http://www.cnczone.com/forums/showpo...32&postcount=9