586,645 active members*
2,780 visitors online*
Register for free
Login

Thread: Emco F1 mill help needed

Results 1 to 4 of 4
  1. 02-02-2010, 11:09 PM #1
    mpostema
    mpostema is offline Registered
    Join Date
    Feb 2010
    Posts
    0

    Smile Emco F1 mill help needed

    I just acquired a Emco F1 CNC mill from a local school. It is in good condition, powers on and all the axis move.

    I do not have any tool holders with it, where can I get them?

    I do not have any operating manuals, where can I get them?

    Thank you!
    Reply With Quote Reply With Quote
  2. 02-02-2010, 11:13 PM #2
    jalessi
    jalessi is offline Gold Member
    Send a message via AIM to jalessi Send a message via Yahoo to jalessi
    Join Date
    Feb 2007
    Posts
    4553

    Post

    The manual is almost 10 megabytes what is your email address?

    Jeff...
    Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
    Reply With Quote Reply With Quote
  3. 02-02-2010, 11:23 PM #3
    jalessi
    jalessi is offline Gold Member
    Send a message via AIM to jalessi Send a message via Yahoo to jalessi
    Join Date
    Feb 2007
    Posts
    4553

    Post

    DNR has the tool holder pull stud.

    http://tinyurl.com/ydqc5k4

    http://www.dnrmfg.com/page3.htm

    Give them a call.

    I believe any 30 taper holder will work.

    Jeff...
    Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.
    Reply With Quote Reply With Quote
  4. 02-03-2010, 04:44 PM #4
    mpostema
    mpostema is offline Registered
    Join Date
    Feb 2010
    Posts
    0
    Jeff, Thanks for the info... [email protected]

    Mark
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. EMCO Compact 5 CNC CPU board needed.
    By dfstrasser in forum Mini Lathe
    Replies: 0
    Last Post: 09-18-2008, 04:01 AM
  2. I need some help with an Emco PC Mill 125
    By Cinci_State_01 in forum Benchtop Machines
    Replies: 2
    Last Post: 05-06-2008, 03:13 AM
  3. Help needed - Emco F1 CNC Mill.
    By Edward Perera in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 2
    Last Post: 04-24-2007, 12:40 PM
  4. EMCO v10 lathe help needed
    By flht1997 in forum Uncategorised MetalWorking Machines
    Replies: 3
    Last Post: 02-07-2007, 04:23 PM
  5. EMCO Compact5 CNC help needed.
    By ESjaavik in forum Uncategorised MetalWorking Machines
    Replies: 5
    Last Post: 07-15-2005, 07:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules