586,655 active members*
2,268 visitors online*
Register for free
Login

Thread: decimal point Gcodes G90.1 G91.1

Results 1 to 1 of 1
  1. 10-22-2009, 08:24 PM #1
    Karl_T
    Karl_T is offline Registered
    Join Date
    Mar 2004
    Posts
    1543

    decimal point Gcodes G90.1 G91.1

    Gcodes with a decimal point are common on modern CNC controls. I've seen no mention of this in the Camsoft literature. It turns out writing Gcodes with a decimal point is easy to do in Camsoft.

    The attached file has modified G90 that also does G90.1 - absolute ijk circular arc, G90.2 - radius mode circular arcs. Also is a G91 that is modified to include G91.1 incremental ijk arcs.

    These Gcodes got a bit more tricky when allowing for more than one G90 or G91 code on a line, i.e. G90 G90.1 Extra bonus question: My Gcodes actually run twice if you have two gcodes on the same line. No harm done, but not perfectly elegant. Anybody have a fix to make this code just run once?

    Enjoy

    Karl
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Forcing a decimal point from a pci
    By inflateable in forum EdgeCam
    Replies: 0
    Last Post: 10-28-2008, 02:58 PM
  2. Illegal use of decimal point
    By barbter in forum NCPlot G-Code editor / backplotter
    Replies: 1
    Last Post: 07-08-2008, 12:06 AM
  3. decimal point
    By stevieboy in forum Mastercam
    Replies: 9
    Last Post: 01-10-2007, 12:42 PM
  4. Decimal point placement
    By Zeekh in forum Haas Mills
    Replies: 5
    Last Post: 11-05-2006, 02:18 AM
  5. help with gcodes
    By turmite in forum Uncategorised CAM Discussion
    Replies: 9
    Last Post: 03-30-2004, 10:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules