After using Mach3 Mill and switching to MachTurn, I am still very much in a learner stage; I have a few comments and questions. I realize the program is work in progress.

1: Is there a problem list so I do not have to carefully document known problems?

2: I miss the tabs or screen selection style of Mach Mill; I can instantly jump to the screen I want. Here I often have to take a detour to the front screen.

3: Why no jogging option in Diagnostic? It is useful if testing limit switches.

4: There is an Edit, Cycle start and Rewind button in the diagnostic page.
Why run a program from there?

5: The Single step button works but there is no LED indicator so I do not know what mode it is in.

6: On "Auto page", the "cycle start" is not a cycle start button, it goes to another screen. I was "scared" to push it since the G-code program was not shown in the "Auto page" screen.

7: There is no indication in the upper left Axis display if it is machine, program, or part coordinates

8: "Set Home" moves at selected homing speed so that is good. "Home" returns to the home positions extremely slowly, maybe just 1% of max. How can I change it? This also magically started to work. See #10 below.

9: I get an error message "Simulating feeds, no spindle feedback" I have a spindle sensor and it correctly displays the RPM

10: Ref/Home LEDs never change, even though I have switches and homing works. Actually this started to work. The following day after restarting the program it looks OK. Maybe it wakes up and works after the program has been restarted if the home functions have been changed

11: What is the "Feedback" LED on the "Auto" - "Run" screen?

12: I select metric mode but the "Run" screen still displays feed in Inches/minute

13: I select Diameter mode, it displays “Diameter” but the DROs are in radius mode

Bertho